Vlasov辐射器反射特性研究

 利用矩量法导出Vlasov辐射器端口处各种模式模系数（振幅）的计算方法，并利用此方法通过数值计算研究了斜切形Vlasov辐射器的反射特性，得到了辐射器端口反射系数和斜切角度及直径波长比之间的关系。结果表明斜切形辐射器具有很小的反射系数，并从反射特性上为辐射器结构参数的选择提供了依据。     

Stability of solutions to the Cauchy problem for a plane hyperbolic system with time-periodic coefficients

Considering a plane hyperbolic system with time-periodic coefficients, we construct a version of the direct Lyapunov method with the condition on the derivative of the Lyapunov functional along the trajectories of the system which is weakened by use of periodicity of the coefficients. We exhibit an illustrative example.     

轴流式水轮机三维非定常湍流计算及压力脉动预测

水轮机的稳定性研究是目前工程上大型水轮机组流动分析的重要课题,本文以某水电站的大型轴流转桨式水轮机原型为基础建立计算模型,完成了从蜗壳进口到尾水管出口整个流道的非定常湍流计算,预测了固定导叶进口、转轮后、尾水管进口等多个位置的压力脉动,并利用FFT变换进行分析得到了压力脉动的频率和幅值,探讨了水轮机全流道内压力脉动产生和传播的原理．     

用转移矩阵法数值研究二维正方介质柱光子晶体的传输特性

利用转移矩阵方法对二维正方介质柱光子晶体的传输特性进行了研究,数值计算研究了不同晶格、同一晶格柱体截面面积不同、放置方位角不同时光子晶体的传输特性。数值结果表明光子禁带的宽度与中心频率和晶格结构有很大关系,正方晶格更易形成平坦光子禁带,柱体截面面积大,则形成的禁带较宽,在其他因素相同的条件下柱体放置的方位角对光子禁带有重要影响。数值研究表明在正方介质柱下设计宽平坦光子禁带时,可以首先考虑正方晶格结构,其次设法使柱体截面尽量大一些,最后可通过柱体放置方位角来微调光子禁带的宽度与中心频率以达到设计要求。     

Evaluation of PLE exhaustiveness for the extraction of PCBs from sediments and the influence of sediment characteristics

Pressurized liquid extractions were performed on eight sediments in order to investigate if a modified US EPA method (100 °C, 100 bar, n-heptane/acetone (1:1), 2 × 5 min) provided exhaustive extractions of polychlorinated biphenyls (PCBs) from sediment, and to study if the extractability of PCBs from the different sediments was affected by characteristics of the sediment. The recovery from the eight native sediments, contaminated in nature, was between 96.4% and 98.9%, as an average of the recoveries from 10 PCB congeners. Hundred percent recovery was defined as the sum of two consecutive extractions (2 × 5 min each) at the stated conditions. The recoveries of the individual congeners were above 94%, except for one congener in one sediment, which had a recovery of 92%. When the recoveries and different characteristics of the sediments were compared, no correlation appeared between recoveries and sediment PCB concentration, total organic carbon (TOC), soot carbon (SC) or amorphous carbon (AC). The fact that carbon did not influence the extractions was somewhat surprising, since previous experiments have indicated a connection. Instead, statistically significant (p < 0.05) correlations were observed for water content and carbon/nitrogen (C/N) ratio. The decrease in recoveries with decreased water content was attributed to less access of the solvent to the analytes due to less matrix swelling. The lowered recoveries with increased C/N ratio can indicate that a difference in structure of the organic matter exists, which influences the binding strength between the analytes and the matrix. The difference in structure can possibly be explained by different origin of the organic matter or by aging effects. Overall the method was found to be exhaustive and the excellent recoveries show that sediment characteristics do not influence the extractions markedly.     

显像管调制特性的测量与分析

测试了显象管调制特性曲线，并分析了特性曲线与显像管工作原理．     

三组元乳化液雾化特性的研究

采用Malvern粒度仪对柴油、甲醇和水三组元乳化液的雾化特性进行了研究。实验发现:对于压力雾化喷嘴来说,本文所涉及的乳化液由于粘度高于纯柴油,因此雾化效果比纯柴油差,而且喷射压力、乳化剂的粘度和乳化液的组份对乳化液的雾化特性具有显著的影响。随着喷射压力的升高,乳化液喷雾粒径将随之减小;若乳化液中柴油的含量(柴油不少于50％)降低,乳化液的雾化粒径将随之增加;若采用高粘度的乳化剂,相应乳化液喷雾的粒径也大。     

X波段五腔渡越管振荡器的理论与实验研究

 提出了一种新结构的X波段五腔渡越管振荡器，进行了理论和实验研究。根据场分布进行了一维非线性分析，结果表明该结构可以产生高功率微波，并判断了工作模式，为TM₀₁模的3π/5模。采用粒子模拟验证了一维非线性分析的结论，并优化设计出五腔渡越管振荡器,优化结果为：输出功率约1 GW， 工作频率9.3 GHz，束波转换效率约22%。实验中，通过参数调节，得到频率约9.25 GHz，峰值功率约780 MW，脉宽（半高宽）21 ns的输出微波，束波转换效率约为16%。实验结果与模拟结果基本符合。     

Space–time integrated least squares: a time‐marching approach

A time‐marching formulation is derived from the space–time integrated least squares (STILS) method for solving a pure hyperbolic convection equation and is numerically compared to various known methods. Copyright © 2004 John Wiley & Sons, Ltd.     

On the tribological characteristics of dynamically loaded journal bearing with micropolar fluids

The addition of the additives to the lubricant oil to enhance the characteristics of the lubricant will influence the performance of the bearings. Based on the theory of micropolar fluids, the tribological characteristics of a dynamically-loaded journal bearing are numerically studied. Comparisons are made between the Newtonian fluids and the micropolar fluids. It is shown that for a dynamically-loaded journal bearing, the micropolar fluids yield an increase not only in the friction force, but also in the friction coefficient. In addition, the oil film pressure and the oil film thickness are obviously higher than that of Newtonian fluids.